Janser PM-1600, Руководство по эксплуатации

Страница: 12 / 15

OPERATING MANUAL
12
Chisel-Stripper
PM-1600
3 OPERATION
3.4 Mode of operation
Hold the machine firmly with both hands by the handles!
Do not start the machine without protective cover!
Wear personal protective equipment!
Make sure that the chisel is not dull. Keep your work environment clean
and free of debris to avoid unnecessary chisel wear.
PVC TILES
Never use a chisel that is wider than the tile.
If tiles can not be removed or the machine jumps over the tiles, use a
smaller chisel.
VINYL, RUBBER, PU PVC FLOORING, BONDED CARPET
Cut the coverings into strips. Pre-cut pads make the machine easier to
steer and increase the life of the chisel.
Cut the webs best with the web cutter JAMAS
CERAMIC TILES
Before removing the ceramic tiles, they must be broken by a hammer.
For small tiles or mosaic laying the break is not necessary.
Start from the door or from a tile-free surface with the distance
so that the chisel can reach under the tiles
Clean off the removed surfaces to get a good ground contact of the chisel.
Use narrow chisel and work with low feed.
WOOD FLOORS
To avoid damaging the chisel, remove nails or other metal obstacles.
For a clean removal of finished parquet or laminate must first be pre-cut
first. A chalk mark with the width of the blade can be drawn to pre-cut on
the pad.
- When removing solid wood parquet always precut cause
it breaks up in small parts.
- When removing plywood panels, the machine should work
in the same direction as the wood grain.
- When working with parquet planks in laying direction, do not work
transversely or across the grain.