Janser MASTER MOBIL II, Инструкция пользователя

Страница: 17 / 25

17
USER INSTRUCTIONS MASTER MOBIL II (111 801 000) 2018-01
Choice of blade
The correct blade size and the correct attachment of the blades, according to the
respective floor covering or subfloor will provide the best performance of your
machine.
Die hier beschriebenen Grundsätze dienen dazu optimale Arbeitsergebnisse zu
erzielen und dem Benutzer die Ausführung seiner Aufgaben zu erleichtern.
Blade size
The harder a job is, you should select the narrowest blade
to achieve optimal results.
Narrow blades usually clean the floor faster, as the machine will
have less restistance as when compared to using a wider blade.
Start with a narrow blade, widen the blade around the optimize cut surface.
Blade bevel
Normally bevel up
blade is up for
concrete.
Self-scoring U-blades
When using self-scoring U-blades for soft floors, pre-cutting of the lining is
unnecessary. Depending on the type of product to be removed and the sharpness
of the blade, it will be more difficult to control the machine.
Therefore, you should always keep the blade and
the side wings/edges sharp.
Insert / replace blade
Blunt blades affect and reduce the capacity and cutting performance of the
machine. Sharpen or replace the blades as needed.
Remove the power plug
CAUTION ! sharp blade Wear protective gloves
Use supplied extended wrench to keep hand safely
away from the edge of the blade.
1. Place a bock under the front of the machine.
2. Loosen the two hex head bolts with the extended bolt
wrench and replace the blade.
It is not necessary to remove the bolts.
Be sure that the blade is far enough under the blade-holder,
to insure a secure hold.
USE ONLY ORIGINAL BLADES.
4 SETUP
4.1 Blade
Bevel down for wood
or soft sub-floors.