Janome dc2015, Инструкция

Страница: 18 / 56

14
z
x
c
v
Inserting the bobbin
z
Place a bobbin in the bobbin holder with the thread running
off counterclockwise as shown on the hook cover plate.
q
End of thread
w
Bobbin holder
e
Hook cover plate
x
Hold the bobbin with your fingertip so it does not rotate.
Guide the thread into the front notch of the bobbin holder.
Pull the thread to the left to pass it under the guide.
r
Front notch
t
Guide
c
Draw the thread to the left to pass it into the guide path
marked “1”.
Make sure that the thread comes out from the side notch of
the bobbin holder.
y
Guide path 1
u
Side notch
NOTE:
If the thread does not come out from the side notch,
rethread from step
z
.
v
Continue to draw the thread along the guide path marked “2”
and pull the thread to the right through the slit. The thread
will be cut to a proper length and held in place.
i
Guide path 2
o
Slit (Bobbin thread cutter)
w q
e
r
t
y
Correct
u
u
u
Wrong
i
o
b
e
b
Set the left edge of the hook cover plate into opening.
Push down the hook cover plate to fit in place.
NOTE:
Unless otherwise noted, you can start sewing without
drawing up the bobbin thread.
Refer to page 17 for how to draw up the bobbin thread.