Janome 5300QDC, Инструкция

Страница: 39 / 84

37
z
e
r
t
The size of a buttonhole is automatically set by placing a
button in the rear of automatic buttonhole foot R.
7KHEXWWRQKROGHURIWKHIRRWWDNHVDEXWWRQVL]HRIß
FPWRßFPLQGLDPHWHU
When selecting the buttonholes, the LCD display advise
you to lower the buttonhole lever.
NOTE:
It is sometimes necessary to change buttonhole size
WRPDWFKFHUWDLQKHDY\RUVSHFLÀFIDEULFVDQGWKUHDGV
0DNHDWHVWEXWWRQKROHRQDQH[WUDSLHFHRIWKHIDEULF
to check your settings.
The preset width of the buttonhole is suited for
ordinary buttons.
$SSO\DQLQWHUIDFLQJWRVWUHWFKRUÀQHIDEULFV
Sewing
z
Pull the button holder to the back, and place the
button in it. Push it together tightly on the button.
q
Button holder
NOTE:
If the button is extremely thick, make a test buttonhole
on an extra piece of the fabric.
,ILWLVGLIÀFXOWWRÀWWKHEXWWRQWKURXJKWKHWHVW
buttonhole, you can lengthen the buttonhole by pulling
the button holder back a little. The length of the
buttonhole will be increased.
w
Extra gap
x
Press the needle up/down button to raise the needle.
Attach the automatic buttonhole foot R snapping the
pin into the groove of the foot holder.
You may lift the presser foot lifter to the extra lifted
position when placing the automatic buttonhole foot
under the foot holder.
Raise the presser foot.
e
*URRYH
r
Pin
c
Draw the needle thread to the left through the hole of
IRRW0DUNWKHEXWWRQKROHSRVLWLRQRQWKHIDEULFDQG
place it under the buttonhole foot. Lower the needle at
the starting point by turning the handwheel.
t
6WDUWLQJSRLQW
q
w
x
c
Square Buttonhole
q
6WLWFKSDWWHUQ 02'(
w
Thread tension dial: 1 to 4
e
Presser foot: Automatic buttonhole foot R
4
w e q