janitza 800-DI14, Руководство пользователя и технические данные

Страница: 26 / 44

26
800-DI14 module www.janitza.de
ESC
 
Duration
Confirm
Ok
30
Identify all modules
ESC
Identify single module
Identify all modules
Diagnostic
 
5.4 Module identification / Diagnostics on the
basic device
INFORMATION
Before you start the module identification function
( Diagnostics menu item) on the basic device, please
make sure that the modules are mounted and con-
nected correctly. Only correctly installed modules
connected to the basic device guarantee the supply
of power and data transmission.
The basic device provides the option of extend-
ing the range of functions using current measuring
modules or digital input modules. The basic device
automatically recognizes the module during the pow-
er-up procedure.
The Diagnostics menu item of the basic device is
used to identify modules that are located at remote
measurement points. After starting the module iden-
tification, the LEDs of the modules being searched
for blink at an interval (see section „5.4.3 Module
identification - LED blink interval“ on page 27).
The module identification can be configured via
the
Diagnostics menu item of the basic device.
Then proceed as follows:
·Press function button 1 ESC to open the menu.
·Use buttons 2 “
5
” and 5 “
6
” to select the menu
item Diagnostics and confirm with button 3 Enter .
·The Diagnostics window appears.
Fig. Window: Diagnostics with entries
·In the Diagnostics window, use keys 2 "
5
" and 5
"
6
" to select the entry Identify all modules or Iden-
tify one module. These mean:
Identify all
modules
Simultaneously identifies all current
measuring modules connected to a basic
device.
Identify one
module
Identifies one module from the module
topology of your basic device.
5.4.1 Entry Identify all modules
·In the Diagnostics window, use buttons 2 “
5
” and
5 “
6
” to select the menu item Identify all modules
and confirm with button 3 Enter .
·The window Identify all modules appears.
Fig. Window, Identify all modules
Time in s that the module
identification takes
(setting range 0-600 s)
Starts the module
identification
(LEDs blink)
·In the Identify all modules window, use buttons 2
“
5
” and 5 “
6
” to select the menu item Duration
and confirm with button 3 Enter .
·The first digit of the entry Duration blinks.
·Use buttons 4 (

) and 6 (

) to change the position
of the digit to be set and buttons 2 (
5
) and 5 (
6
) to
change the digit (-1/+1).
·Confirm your entries with key 3 Enter .
·Use keys 1 ESC and key 5 "
6
" to access the entry
Confirm .
·Press button 3 Enter.
·In the entry Confirm , OK blinks.
·Pressing key 3 Enter starts the identification of all
modules using a blink interval of the LEDs (see
section „5.4.3 Module identification - LED blink
interval“ on page 27).