janitza 800-DI14, Руководство пользователя и технические данные

Страница: 27 / 44

27
www.janitza.de
800-DI14 module
ESC
 
Duration
Confirm
Ok
30
Module position 1
Identify single module
Tx
Rx
P
E
Tx
Rx
P
E
Item Description
1
Blink "orange" during operation and signaling cyclic
data exchange (Tx ... Transmit data, Rx ... Receive
data).
2
Lights "green" if the supply of power via the JanBus
interface of the basic device is correct, the device is
ready for operation (P ... Power).
3
Lights "red" during initialization/startup and in the
event of a fault (error). Note in this regard Sect.
“13.2 Modules - Error cases” on p. 38.
LED status of the module in operation:
1
2
3
Item Description
1
Blinks "orange" for the Duration of the module
identification.
2
Lights "orange" for the Duration of the module
identification.
3 Lights "green".
4 “Off”
LED status of the module during module identifi-
cation:
1
2
4
3
INFORMATION
During the Duration of individual module iden-
tification , the blink intervals of all other modules
connected to the basic device are paused!
5.4.2 Entry Identify one module
·In the Diagnostics window, use buttons 2 “
5
” and
5 “
6
” to select the menu item Identify one module
and confirm with button 3 Enter .
·The Identify one module window appears.
Fig. Window: Identify one module
·In the Identify one module window, use keys 2 “
5
”
and 5 “
6
” to select the menu item Module position
and confirm with key 3 Enter .
·The entry Module position blinks.
·Use the keys 2 "
5
" and 5 "
6
" to enter the position
number of the module to be identified (the position
number depends on the number of modules con-
nected in series to the basic device).
·Confirm the entry with key 3 Enter .
·Use keys 1 ESC and key 5 "
6
" to access the entry
Duration .
·Press button 3 Enter.
·The first digit of the entry Duration blinks.
·Use buttons 4 (

) and 6 (

) to change the position
of the digit to be set and buttons 2 (
5
) and 5 (
6
) to
change the digit (-1/+1).
·Confirm your entries with key 3 Enter .
·Use keys 1 ESC and key 5 "
6
" to access the entry
Confirm .
·Press button 3 Enter.
·In the entry Confirm , OK blinks.
·Pressing key 3 Enter starts the module identi-
fication with a blink interval of the LEDs on the
corresponding module (see section „5.4.3 Module
identification - LED blink interval“ on page 27).
Position of the module
in
the order of the basic
device’s module topol-
ogy.
Time in s that the module
identification takes
(setting range 0-600 s)
Starts the module
identification
(LEDs blink)
5.4.3 Module identification - LED blink interval
The module identification (diagnostics) procedure
started on the basic device triggers a blink interval
of the LEDs on the modules. The blink interval of
the functions
Identify one module and Identify all
modules works the same way for a single module or
for all modules!