background image

SECTION 3. Installation Instructions

7

SECTION 4.

Start-Up and Operation

  

4.1 Preparing Diatomaceous Earth

Your filter requires diatomaceous earth (DE) for proper 
filtration  and  operation.  The  filter  grids  must  be 
precoated  with  DE  in  order  to  protect  their  surfaces 
and provide the most efficient filtering action. Refer to 
Table 3 for the proper quantity of DE to use with your 
filter.

1.  Using  a  one  (1)  pound  coffee  can,  fill  the  can  with    
diatomaceous earth (DE). Do not pack or compress the   
DE into the can. 

2. Mix the required amount of  DE with sufficient water 
in  a  separate  bucket  to  make  a  thin,  milky  mixture 
(slurry).  Note:  Excess  DE  will  clog  the  system.  Use 
amount specified in this manual. 

3.  Use  the  following  instructions  to  coat  the  filter      
grids.

4.2 Coating the Filter Grids

1. Prepare recommended amount of DE as outlined in    
Section 4.1.

2. Start the filter system as outlined in Section 4.3.

3. With the pump running and the pool skimmer valve   
open,  slowly  pour  the  mixture  directly  into  the  pool's    
skimmer basket. The slurry will be drawn into the filter.

4.  After  coating  of  grids,  rotate  the  bezel  of  the      
pressure  gauge  so  that  the  arrow  next  to  the  word   
"CLEAN" is aligned with the needle of the gauge. This   
marks the original starting pressure of the system.

5.  Clean  the  filter  when  the  pressure  of  the  system      
increases  so  that  needle  of  the  gauge  aligns  with  the    
arrow  next  to  the  word  "DIRTY"  on  the  bezel  of  the    
gauge.  This  indicates  an  increased  pressure  of     
between 10 and 12 psi above original starting pressure.

                              WARNING

NEVER  start  pump  while  standing  within  five  (5)      
feet of the filter. Starting the pump while there is    
pressurized  air  in  the  system  can  cause  the  filter 
lid  to  be  blown  off,  which  can  cause  death,       
serious personal injury or property damage.

                              WARNING

NEVER  operate  the  filter  system  at  more  than      
50 psi of pressure. Starting the pump while there    
is  pressurized  air  in  the  system  can  cause  the      
filter  lid  to  be  blown  off,  which  can  cause  death,          
serious personal injury or property damage.

                              WARNING

Changing  the  multiport  valve  handle  while  there      
is  pressurized  air  in  the  system  can  cause  the      
filter  lid  to  be  blown  off,  which  can  cause  death,          
serious personal injury or property damage.

                              CAUTION

Dust  released  during  normal  handling  of 
diatomaceous earth can cause eye and respiratory 
irritation.  Prolonged  breathing  of  excess 
concentrations of dust may cause lung damage.

                              CAUTION

Never  operate  filter  in  excess  of  three  (3)    
minutes  without  use  of  diatomaceous  earth     
(DE).  DE  is  the  substance  that  filters  the  water,      
the  filter  cloth  merely  supports  the  DE.  Operat-    
ing  without  DE  will  damage  filter  grids  and      
shorten filtering cycles.

                              CAUTION

DO  NOT  operate  filter  at  water  temperatures            
above  120°  F  (65.5°  C).  Water  temperatures    
above  the  manufacturer's  recommendations  will    
shorten  the  life  span  of  the  filter,  and  void  the         
warranty.   

Model                   DE Quantity              No. of 1 lb.
Number                  (lbs.) (kg.)                coffee cans

DEL48                      5.0    2.0                          10     
DEL60                      6.0    2.7                          12      
  

Table 3. DE Slurry Mixture

Содержание DEL Series Filters
















Отзывы: