USG-00000-JLXLITEMKII [1.0]
JLX LITE MKII
6
the socket as a locating guide. Unused mains socket holes must be protected with a metal
cover.
16. Remove the clear protective coating from the covers.
17. Fit the covers. The covers must be secured using the screws provided.
18. Fit the supplied end plugs to any open ends of the bar.
19. Fill out the installation record.
2.5
Perch Bar (Vertical) Installation
The JLX-LITE-MKII is not designed to resist significant end loads. A Perch Bar option allows the JLX-
LITE-MkII to be mounted so the bar is on its end (90 degrees from horizontal) for Perch or Box Boom
locations, but may also be used where the bars are at other angles. The Perch Bar option should be
used any time the bar is more than a few degrees off horizontal as shown by a spirit level. Always
mount the Perch Bar option at the low end of the bar.
When correctly installed the Perch Bar option allows the JLX-LITE-MkII bar to be used at the rated
working load limit. Note at high bar angles the bar will transfer the bulk of the load to the supporting
structure via the Perch Bar mount at the bottom. Hence this mount must be well fixed to the supporting
structure using multiple solid anchors that include a high shear strength.
1. Install the supporting structure. See the available options and notes in section 2.2.
2. Install the lower Perch Bar mount. Use a minimum of 4 substantial fixings. Do not mount to plas-
terboard or use wall plugs.
3. Remove the JLX-LITE-MkII dress covers by removing the screw and sliding the cover along the
bar enough so it can be angled out of the available gap between the bar supports. Put the cov-
ers and screws to the side with the other supplied accessories.
4. Orient the bar as it is intended to be hung, checking the mains outlets are on the required side.
DUCT
