IS309-22G
J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com
Page 5/6
Installing High Pressure Fog Nozzles:
• Using your fingers, screw in and tighten the (8) Anti-Drip High Pressure Nozzles into the
nozzle ports.
-
Hand tighten only
.
- Tools are not recommended as they damage and over tighten the nozzles.
-
DO NOT OVER TIGHTEN
WARNING: Do not remove nozzles or plugs while system is running.
5
Connecting the Ring to Your HPF System:
•
Slip lock connectors requires the nylon tube be cut straight, cleanly, and without crimping or
deforming the tube while cutting.
• Insert the end of the nylon tube into the slip lock until you meet some resistance then push it
in another 1/2” or so until it stops.
NOTE:
If you need to remove the nylon tube from the slip lock, the system must be depressur-
ized. Then push the metal slip lock collar back into the fitting and pull the nylon tube out.
Once the nylon tube has been fully inserted into a slip lock and is removed, even for a
short time, 1” of nylon tube (the amount that was inserted into the slip lock) must be
trimmed off or it will not seal properly. Keep this in mind if you intend to disassemble
your system seasonally as you will want to provide additional tubing to those sections
to allow for yearly trimming until you are required to replace your nylon tubing.
6
Use Hand Only
(no tools)
