Getting Started
HT1
User Manual
Janam Technologies LLC Version 1, September 2020
Getting Started 2—2
Charging the Janam HT1 Rugged Tablet
BATTERY SAFETY GUIDELINES
The HT1 has a removable and rechargeable battery. Replace only with a Janam-approved battery.
There is the risk of explosion if the battery is replaced by an incorrect type. For more information on
battery replacement contact JanamCare at 866-915-5311. Use only battery chargers approved for
the HT1 by Janam. Janam and its affiliates disclaim any liability for damage caused by the use of
other chargers or batteries. Observe the following guidelines for safe use of Li-Ion batteries:
1. Do not expose the battery to excessive heat or cold. Do not short-circuit. Do not incinerate.
2. To avoid risk of fire, burn or damage to your battery, do not allow a metal object to touch
battery contacts.
3. Do not disassemble the battery. There are no user serviceable parts inside.
4. If battery leakage is observed, avoid any contact with affected area and properly dispose
of the battery.
5. If you come in contact with battery leakage, rinse exposed area with soap and water.
If it contacts the eye, flush the eye with water for 15 minutes and seek medical attention.
6. Dispose of used battery promptly. Keep away from children. Do not disassemble or
dispose of in fire.
7. When discarding a battery, contact your local waste disposal provider to understand
local restrictions for disposal or recycling of batteries.
BATTERY CHARGER SAFETY GUIDELINES
1. Do not use the equipment in or near areas in which sparks are likely or possible.
2. Do not let equipment’s metal contacts and electrical sockets come in contact with metal objects.
3. For indoor use only. Do not expose the equipment to rain or any liquids.
4. Do not use or store the equipment in direct sunlight or in areas that are prone to get hot
such as in a parked vehicle, near a heat duct or close to other heat sources.
5. Keep equipment’s metal contacts and electrical sockets free from debris that could
obstruct charging or could cause a short circuit.
Installing the HT1 battery
To install or replace the HT1
battery, you must first remove
the battery compartment cover
on the back of the unit. To do this
start with sliding the two cover
lock sliders to the left and right
of the cover, as well as the two
sliders at the bottom of the cover
into the open position. The open
position is marked with an open
padlock icon.
