Jamara 006143, Инструкция

Страница: 23 / 28

23
Take tail wheel, 2mm collar and M3x4 hex screw out of hardware
bag. Install tail wheel to the tail gear and put on the collar. Keep
the distance between the wheel and collar around 1.5mm and
secure the collar in place with M3x4 screw.
Attach the clevises onto their respective horns on the elevator
and rudder. Slide the silicone tube over the clevises for providing
extra insurance against the clevises accidentally coming open.
Keep the distance between the end of the tubing and the end
of rod around 15mm; us instant glue to secure the tubing on the
fuselage.
Pull the tubing through planking (in the front of the servo tray)
tight and use instant glue to secure the tubing in place.
Drop some instant glue onto the servo securing holes on servo
tray for reinforcing the securing ability when screw in.
Place the servos, rod connectors, plastic nuts and M3x4mm hex
screws on the working table. Use 2mm driller to drill the out-most
hole on the servo arm. Install the rod connectors into the out-
most hole and secure with plastic nuts and M3x4mm hex crews.
Do screw too tight; make sure the rod connector can move freely.
Set the servos at neutral position and secure on the servo tray
with provided screws. Release the hex screw and insert the rod
through the rod connector. Keep the distance between the end of
the rod and the end of the tubing around 15mm; set the elevator
align to the horizontal and secure the rods by tightening the hex
screw. Set the rudder aligns to the vertical and secure the rod by
tightening the hex screw.
Place the ESC, propeller, aluminum nut, motor and its relative
accessories on the working table.
Place the cross metal mount on the fire wall and set the cross
mark on the center position of the metal mount. Use maker to
mark the out-most 4 holes on the cross mental mount.
Use 2.6mm driller to drill open the 4 marked holes on the fire wall.
Drop dome instant glue into the holes for reinforcement.
Use hobby knife to cut off the center circle hole on the fire wall.
Secure the motor on the cross metal mount with provided
screws. Connect the motor with ESC, set the ESC through the
hole on the fire wall and secure the ESC on the bottom of the
fire wall with Velcro tape. Secure the motor onto the fire wall with
3x16mm tapping screws.
COVERING AND FINISHING THE MODEL