Jamara 006143, Инструкция

Страница: 19 / 28

19
Try to find the pre-serving holes on the main wing for servo, for
cable exit, for screw and for horn as the picture shown.
Use soldering to melt out the covering over these holes. Drop
small instant glue on screw holes for reinforcement.
Place the bottom wing and wing reinforcement on the working
table with the back facing upward.
Use soldering to melt out the covering over the screw holes.
Spread glue on the wing reinforcement and secure it onto the
bottom wing. Make sure the alignment of the rear edges and
the screw holes.
Use clip to hold the wing reinforcement in place for temporary
until the glue dried enough.
Try to find the pre-serving 8 holes for both sides of fuselage.
Please refer to the picture. (7 holes are for screw; 1 bigger hole
is for cable exit)
Use soldering to melt out the covering over these holes. Drop
some instant glue on the screw holes for reinforcement.
COVERING AND FINISHING THE MODEL
Place the front cover of the fuselage on the working table. Try to
find the preserving 10 holes on it as the pictures shown.
Use soldering to melt out the covering over these holes.
There are two holes on the tail of the fuselage for securing the
tail gear mount.
Use soldering to melt out the covering over the holes.
There are two pre-serving holes on the top of sub wing. Please
refer to the picture.
Use soldering to melt out the covering over the holes for instal
-
ling the gear.
There are pre-serving slots on both sides of the sub wing.