Jamara 006143, Инструкция

Страница: 5 / 28

5
Make sure the alignment of ribs on the W5; press the ribs into
its relative slots on the MW5. Drop instant glue to secure them
in place.
Please check if there is any joint places need to be secured by
instant glue. Apply some UHU glue on the joint places of leading
edge (dowel) and ribs. Wipe off the excess glue.
Use sanding paper to trim the uneven surface, wing tips and rear
edge; wait for apply films.
Place MW15 and MW16 on the working table. MW16 will be ap
-
plied film on one side. MW15 won‘t need any film. Don‘t glue
MW15 and MW16 to the bottom wing right now.
BOTTOM MAIN WING ASSEMBLY
Place the DW7 (4 pieces) and DW8 (2 pieces) on the working
table as the picture shown.
Use glue to secure DW7 on both sides of DW8. Make sure the
alignment of the edges and use clip to hold the combination tem-
porary until the glue is dried enough. Drop some instant glue on
the edges.
Top view of the DW7 combinations. There is one small hole on
the top.
LANDING GEAR SUB WING ASSEMBLY
Place the following parts on the working table in order:
DW1 leading edge
DW7 (2 pieces)ribs
DW6 (2 pieces)ribs
DW5 (3 pieces)ribs
DW2. middle edge
DW3 secondary edge
DW4 rear edge
Try to fit ribs to the DW2 and DW3.Don‘t use any glue now. Try to fit 2 pieces of DW7 on both side of sub wing. Please note
the hole on DW7 must face the upward.
Place MW13 and MW14 on the working table.
Fit the MW13 to the main wing as the wing tip. Fit the MW14 into
the slot on the middle edge between the main wing and MW13.
The angle between the MW14 and MW13 must be 90 degree.
Drop some instant glue to secure the MW14 in place.