page: 13 / 20
●
If the awning were hanged in brackets, the hood Profile "Y" must be
raised enough to easily put up the awning in the brackets.
●
Awning put up in the brackets and insert supporting tubes in the
lane.
●
Awning in brackets secure with screws M8 using a wrench/ring
spanner Nr5.
●
Bring hood profile “Y” down.
●
Clamping plates
„
Z” tighten.
●
Screw on the hood with the enclosed screws.
3.8.4.2. Awning Installation without the Hood (Standard)
Note
Awning is heavy and bulky. Make sure that the number of people is sufficient to mount
the awning to its size and weight.
●
The awning hang in the
console and insert the support tubes in the
mounting hole.
●
Awning with brackets secure with
screws M8 using allen key Nr 5.
3.8.5. Pitch Angle Adjusting
Adjust the pitch angle the awning, so that the minimum height from the ground was not less than 220 cm.
Note
If a pitch angle the awning has less than 14° it is necessary to roll up device in case of
a rain as this could damage the awning construction.
CAUTION!
The Arms are under extreme tension. Risk of personal injury!
