Page 28
VIS CAM 300/400 Installation Manual
Installing the Vehicle Imaging System
3.4 Illumination Options
3.4.1 Installing the TNF-31 Flash
The connection to the Flash unit in the VIS CAM 300 is shown in Table 9 and
Figure 26.
FIGURE 26.
TNF-31 flash unit
TABLE 9.
Flash unit connection in VIS CAM 400.
The cable from the flash unit is connected to the VIS CAM 300 I/O Board as shown in figure 3.17 and
3.18. There are two examples shown: one where the output circuit on the I/O Board is powered from the
flash unit and one where the output circuit is powered from the I/O Board.
It is recommended that I/O Board output circuit be powered from the flash unit in order to obtain
galvanic isolation between the to units. In cases where this is not possible (such as when using mains
supplied flash units) power is taken from the I/O Board.
The cable must be shielded and the shield connected to the metal at the cable entry in the camera house.
The switch labelled S3 on the VIS CAM 300 I/O Board must be in position “NIGHT L” (away from
connector X5 as shown below).
FIGURE 27.
S3 switch setting
Pin
Signal
Description
Connection to
1
I/O Gnd
IO Board Gnd
Pin 2 when no power is available from the flash
2
Gnd
Flash Gnd
Flash ground (negative power terminal)
3
Out
Strobe out
Strobe input on flash unit
4
Stat
Strobe status
Status output from flash unit
5
FPWR
Flash power
Power from flash to output circuit on I/O Board
6
24V
IO board 24V (Fused
0.5A)
Pin 5 when no power is available from the flash
1 2 3 4 5 6
Содержание Vehicle Imaging Subsystem 300
