JAI AM-1600CL, Руководство пользователя

Страница: 49 / 61

AM-1600CL / AB-1600CL
- 49 -
Calibration must be performed in the sequence of [Dark] first, then [Bright]. Begin by
clicking the [ RUN ] button in the [Dark] section. A pop-up window will instruct you to
close the lens before continuing. Calibration will then proceed automatically untill
completed. The status window next to the [
STOP ] button shows the percentage of
completion. It can take up to 20 minutes for a calibration to be performed. Click the
[ Stop ] button to halt the calibration at any time.
When [ Dark ] calibration is completed, click the [ RUN ] button in the [ Bright ] section. You
will be prompted to open the lens to a saturation level of approximately 50% before
continuing. Calibration will then proceed automatically unless halted by clicking the
[ STOP ] button.
Both [Dark] and [Bright] calibration must be performed as a set. [Dark] only or [Bright]
only cannot be initiated.
After running both [
Dark ] and [ Bright ] calibration, the data should be saved to Flash
memory to avoid having to rerun calibration. Click [ Start ] button in the [ Save ] section to
save the data. The process can take up to 40 minuates.
If a flat field compensation mode has been selcted and saved via the [
Save RAM to Flash ]
command on the Gain & Offset page, the calibration settings will be automatically loaded
to the Camera at start-up (the rear panel indicator light will turn red during the loading
process, which may last a few minutes).
Use the [
Load ] section to load pre-saved calibration data from Flash to RAM.
Use the [ verify ] section to compare new calibration data in RAM to saved data in Flash
memory.
8.7.2(d) Utilities
On this screen, model name, firmware versions and test patterns are indicated.