P/N 2412800000 REV. C 6/2011
Page 4
The
convection oven has
a pilot re-ignition safety feature. This feature runs on 120V system
using the pilot, thermocouple and Baso safety valve. To operate the pilot re-igniter, the master
electric switch (toggle switch) located at the control panel must remain in “ON” position. If the
pilot flame and oven burner flames are extinguished by drafts or temporary loss of gas (less
than 5 seconds) the pilot will attempt to re-ignite by sparking. Should the thermocouple cool
down (over 5 seconds) the safety valve closes and shuts down the gas supply to the oven
burner. The sparking will
NOT
stop until the pilot flame is re-established while the unit is under
power. To re-establish the pilot flame, follow the lighting procedures below.
Convection Oven Section Lighting Procedure:
With main gas supply on and top burner pilots ignited, continue with lighting the oven pilot
1. Flip master toggle switch to “ON” position. The indicator light will glow.
2. Remove oven kick plate.
3. Push red button of safety pilot valve and light pilot. Continue to push red button until pilot
flame remains on (minimum of 30 seconds). Release button.
4. Turn oven gas valve to fully on position.
5. Turn thermostat dial to desired temperature. Check oven burner ignition.
6. Check if pilot flame is extinguished of not.
7. Turn off thermostat.
8. Check pilot flame (still ignited).
9. Replace oven kick plate.
Convection Oven Section Operation
1. Turn oven gas valve to fully on position.
2. Turn thermostat to desired temperature.
3. Flip blower toggle switch to “AUTO” position to turn blower on.
If it is necessary to lower oven temperature very rapidly to accommodate a different product,
simply adjust thermostat to the lower selected temperature. Open oven door and flip blower
CAUTION:
When possible,
DO NOT
operate convection oven
with oven blower OFF for more than 2 minutes.
