ThingMagic Sargas User Guide
|
10
3 Development Kit Quick Start Guide
3.1.1
Figure 1: Assembled Development Kit and Reader
If you have purchased a Sargas Development Kit with your Sargas reader, you will have received the following
accessories. (The numbers following the descriptions are the ThingMagic SKU numbers, should you wish to
purchase additional units.)
AC Adapter with international plugs (PWRADP-S6-MR)
RP-SMA to RP-TNC cable adapter (CBLADP-1)
RP-TNC to RP-TNC RF Cable (CBL-P6)
RFID Antenna (ANT-WB-6-2025)
LAN cross-over Cable
Sample Tag Pack (TM-TAG-KIT)
To make the required physical connections to the reader:
1. Attach RF cables to each other, to the ANT1 port of the reader, and to the antenna as shown in Figure 1.
2. Attach the LAN cable to the reader and to your network or directly to your PC. Note that a cross-over cable is
not needed. Either the Sargas LAN interface or your PC will adjust their polarity to compensate for the other
side.
3.1.2
Figure 2: Power, LAN, and RF Connections to the Reader
3. Connect the 5V DC power adapter to the Sargas Reader. Install the correct prong assembly for your AC
service onto the adapter and plug it into an AC outlet.
WARNING -
Powering the reader with a USB cable is not supported.
