Jacuzzi sasha mi, Использование и обслуживание

Страница: 44 / 92

44
Activating the hammam depends on how many times the various different pro-
grams have been run already. If it is between 40 and 60 times, when pressing the
button for one of the programs, the water-pitcher symbol on the display flashes (a
blue light) for a few seconds. This means that a scale-removal cycle should be run
(but the hammam function can still be used).
However, when the maximum number of steam cycles (60) has been reached,
the function is no longer available (the water-pitcher symbol flashes white) . You must
run a scale-removal cycle.
As an exception, the scale-removal cycle can be delayed and the hammam
function can continue to be used a certain number of times.
Always refer to the “Scale-removal cycle” section.
Q
If desired, you may enrich the steam bath using your own preferred essences or suitable
scented oil sticks: remove the dispenser from its housing, as indicated, and insert one oil
stick per dispenser; or use a few drops of your preferred essence. Re-close the dispenser,
pressing it down until it locks.
The oil sticks are available from Jacuzzi® Service Centres; we advise cutting the oil stick into
two pieces, and placing one in each dispenser.
Q
Turn on the main switch: the system will enter into "awaiting instructions" mode and
the ON/OFF display key will light up white.
NOTE: when the appliance is powered, you must wait several minutes before using the
hammam (the thermometer symbol flashes when the ON/OFF button is pressed); this time
period allows the control system to initialise the electronic management system.
Q
At the end of this phase (the thermometer symbol stops blinking) , press the ON / OFF
button: the blue button light switches on and the programme keys - alarm and water
softener keys - simultaneously light up. Now the key panel is ready to receive input
commands.
NOTE:
- This mode lasts approximately one minute, after this time, if no key has been pressed, the
system reverts to "awaiting instructions" mode.
- The activation of any key is indicated by an acoustic signal.
- If an audio kit is installed (optional), the keys relative to the audio system , will also light up
on on the display.
preliminary operations
programme
activation
Note regarding operation
of the hammam and the
scale-removal cycle
A “steam cycle” is understood
to mean the activation of one
of the available programs