57
“FREEZE PROTECTION”
A potential freeze condition has
been detected. No action is required. Jets pump(s) operate until
the spa is out of danger. No corrective action is necessary.
I
If
condition persists, contact your authorized dealer or service
organization.
“OVERHEAT PROTECTION”
Do not enter the water!
Water temperature is above acceptable limits. Heater is deacti-
vated. Remove spa cover to speed cooling.
I
If condition persists, contact your authorized dealer or serv-
ice organization.
Note: The heater icon (
) will be blinking and the error icon
(
) will be displayed under the temperature.
As an extra safety measure, the hot tub lights flash with a red light.
Risk of Hyperthermia (over-heating) Causing Severe
Injury, burns, or welts.
“WATCHDOG PROTECTION”
DO NOT ENTER SPA!
Water temperature is above acceptable limits. Your spa is deac-
tivated. Remove spa cover to speed cooling.
I
If condition persists, contact your authorized dealer or serv-
ice organization.
Note: The heater icon (
) will be blinking and the error icon
(
) will be displayed under the temperature.
Risk of hyperthermia, burns and scalds.
“WATCHDOG FREEZE PROTECTION”
Spa water is below 40°F/4.4°C. Jet pumps operate until the
spa is out of danger.
I
Contact your authorized dealer or service organization.
Note: The heater icon (
) will be blinking and the error icon
(
) will be displayed under the temperature.
“CONTROLLER OVERHEAT PROTECTION”
Controller temperature has exceeded acceptable limits. If con-
dition persists, provide shade for equipment side of spa.
I
Contact your authorized dealer or service organization.
Note: The heater icon (
) will be blinking and the error icon
(
) will be displayed under the temperature.
“PANEL COM ERROR”
The topside controller is having trouble communicating to your
spa.
I
Contact your authorized dealer or service organization.
“STEREO COM ERROR”
The stereo is having trouble communicating to your spa.
I
Contact your authorized dealer or service organization.
“CLEARRAY REPLACEMENT REMINDER”
This message will appear when the CLEARRAY bulb reminder
time has expired.
I
The CLEARRAY bulb must be replaced.
“PROCLARITY/PROCLEAR FILTER REMINDER”
This message will appear when the filter reminder time has
expired.
I
Remove the ProClarity/Proclear filters and filter/debris bag
for cleaning or replacement.
“PROCLARITY DEPTH FILTER REMINDER”
This message will appear when the filter reminder time has
expired.
I
The ProClarity Depth filter must be replaced.
“WATER REFRESH REMINDER”
This message will appear when the “Water Refresh” timer has
expired.
I
The water needs to be drained and refilled with fresh water.
“EXTENDED TEMPERATURE ACTIVATED”
The spa is set to go up to 40°C (104°F), but it can be set to reach
41°C (106°F). To access the extended temperature you need
press and hold your finger over the temperature reading for
about 5 seconds. The temperature reading will start to blink to
indicate the system is ready. Tap (
)
to raise the tempera-
ture up to 41°C (106°F).
Note:
The heater icon (
) will be blinking to indicate that
the feature is active.
ON
ON
ON
ON
It’s time to replace your CLEARRAY bulb.
Contact your authorized dealer for replace-
ment parts.
Reminder
reset
snooze
It’s time to clean or replace your ProClarity
and ProClear filters. Contact your autho-
rized dealer if new filters are needed.
Reminder
reset
snooze
It’s time to replace your ProClarity Depth
Filter. Contact your authorized dealer for a
new filter.
Reminder
reset
snooze
Your spa needs to be drained and refilled
with fresh water. Refer to your owner’s
manual for draining procedure.
Reminder
reset
snooze
ON
Содержание J-500 Series
Страница 2: ......
Страница 3: ...Italiano Avvertenze 4 English Warnings 32 Fran ais Recommandations 59 Index...
Страница 90: ...90...
Страница 91: ...91...