![background image](http://html1.mh-extra.com/html/jacuzzi/era-6636/era-6636_installation-and-operation-instructions-manual_629872007.webp)
Era™ Freestanding Bath
Era™ Freestanding Bath
Installation and Operation
www.jacuzzi.com
Page 7
English
Claw Feet Attachment
X
X
Turn the bath upside down on a protective covering and attach the four
(4) claw feet to the bathtub (Figure 2).
Place the larger pair of claw feet towards the back of the bathtub (the
back is higher than the front).
X
Y
Using a flat washer, lock washer and hex head bolt, attach the claw feet
to the bath tub. Repeat this step for the remaining three (3) claw feet.
X
Z
Once all four (4) feet have been installed, use an Allen wrench
(supplied) and tighten all mounting hardware.
X
[
Place the bath upright on the protective covering.
Figure 2.
Claw Feet Installation
Slipper Base Installation
Before installing the Slipper Bathtub, please make sure that the permanent location of the Slipper bathtub has
been determined.
It is strongly recommended that a licensed plumber perform all plumbing and plumbing assembly procedures.
It is strongly recommended that two people perform the following steps.
Bathtub
Rubber Gasket
Flat Washer,
Lock Washer and
Hex Head Bolt
Step 1
Figure 1.
Slipper Bathtub Placement
Slipper Bathtub Placement
X
X
Center the bathtub with the water supply lines that are located on the floor.
X
Y
Measure 6" from the center of the water supply line to the center of the bathtub drain opening (Figure 1).
Leave the Slipper bathtub in this location and proceed to the "Installation" section below.
It is strongly recommended that two people perform the following steps.
6"
8" from
the wall
(minimum)
5¾"
1" Diameter
Hole
1½" Diameter Hole
Hot Water
Cold Water
Rim of Bathtub
Drain/Overflow Tube
Water Supply Lines
Water Supply Lines
If you cannot access the notch cutout because the mounting bracket is in the way, use an Allen wrench (supplied)
and loosen the hex head bolts. Slide the mounting bracket up and then retighten the hex head bolts. Performing
this step will provide room to access the notch cutout.
Installation