6
JACUZZI
®
JAG ROBOTIC CLEANER
1. Plug power supply into a GFCI outlet (Ground
Fault Circuit Interrupter) (Figure 1). Power Supply
must be 5 ft. from the pool's edge.
Figure 1. Plug into Power Supply
2. Straighten the floating cable. Lift the flap on
the power supply and plug in the power cable
(Figure 2).
Figure 2. Connect the Power Cable
SECTION 4. INSTALL THE
CLEANER
CAUTION
To prevent damage to the cleaner, be sure to adhere to
the following guidelines:
• Remove the cleaner from the pool after the cleaning
cycle is completed.
• Store cleaner out of direct sunlight out of direct
sunlight or inclement weather.
•
Never lift the cleaner out of the pool by the floating
cable.
• Take additional care when lifting the cleaner out of the
pool. It becomes heavier when filled with water.
• Always remove the cleaner from the pool before super
chlorinating or adding acid.
• Do not handle cleaner while it is in operation.
IMPORTANT
• Always make sure the cleaner head is fully
submerged before you begin operation.
• Clean out debris after each cleaning cycle.
• Do not leave your cleaner in the pool on a
permanent basis.
• At the end of each cycle, remove the cleaner from
the pool.
• Start at the cleaner head and untangle any coils in
the cable before storing the cleaner.
4.1
SUBMERGE IN THE POOL
1. With the control box plugged into a GFCI outlet,
spread the floating cable across the pool deck
until you reach the middle of the pool length.
NOTE:
For optimal patterning and reduced tangling, the
floating cable should enter the water near the middle
of the pool length.
