Jacob Jensen Electronic Parking Disc, Руководство пользователя

Страница: 13 / 16

18
|
UK UK
|
19
Activation of the parking function
Before you use the disc for parking and after changing the batteries, you
should always ensure that the parking function is correctly set and that
the parking time is displayed correctly.
With the engine running, press ’SET’ and ’ ’ simultaneously. Hold both
keys down until one short beep is heard. Release the keys and wait for
two short and one long beep. A ‘P’ icon will appear in the lower left-
hand corner of the inside display. The product is now activated and ready
for use.
The product can be reset to its original factory settings at any time. This
can be done by removing the front of the product and pressing a small
pin into the ’RESET’ hole.
When the car is parked (the engine is switched off), both displays will
always show the parking time - the keys lock after five minutes, unless
they have been switched off manually.
When you are driving (the engine is switched on), both displays will
always show a clock after driving for approx. two minutes - unless both
displays are switched off manually.
If no keys are pressed before the parking function is activated, the two
displays will automatically switch off within two minutes. The clock
and the automatic search for the radio signal will remain active even
though the display is switched off. The displays switch on again if you
press any key before the parking function is activated.
1. Thoroughly clean the area on the inside of the windscreen where you
intend to attach the product. Use Isopropyl alcohol or acetone.
2. Remove the protective film from the three small adhesive pads on
the flat side of the product and affix the disc to the lower right-
hand corner on the inside of the windscreen.
3. It is important to ensure that the large display on the outside of the
product is visible from outside the car.
Mounting the device
Positioning is important
For the product to act as a valid parking disc the Danish Road Safety and
Transport Agency requires that it is correctly fitted in the lower right-hand
corner on the windscreen of the car.
You only have to set the disc once
When you have set the parking function as described below, the product
is ready for use. You must set the product before it can be used. After this
initial setting, you will not have to set the product again until you replace
the batteries.
By pressing ’SET’ it is possible to toggle between the following three functions:
1. Clock,
2. Parking time
3. Displays off