Jacob Jensen Electronic Parking Disc, Руководство пользователя

Страница: 14 / 16

20
|
UK UK
|
21
When the car is parked
Every time the car is parked and the engine switched off, the setting of
the parking time is indicated by two short beeps. The Electronic Parking
Disc will automatically set the parking time forward to the nearest quar-
ter of an hour. For example, if you park the car at 14:05, both displays
will set the parking time to 14:15. It is possible to change the parking
time manually for up to five minutes after you have parked the car.
1. Press the ’SET’ key and hold it down for a couple of seconds.
Adjust the parking time by using ’ ’ or ’ ’.
2. If you park the car in an area without parking restrictions,
you can switch off the displays by pressing ’SET’.
If the parking time is not changed manually, the keys will lock after
five minutes have elapsed.
When the car is moved
When you start the engine and drive the car, both displays change
back to a standard clock after approx. two minutes depending on driv-
ing mode. The keys have been unlocked automatically after 30 sec-
onds. Please be aware of this if you only drive for a short while. You
might then have to set the parking time manually.
Troubleshooting & good advice
If the product’s clock is not picking up a sufficiently strong radio signal,
it may be due to:
1. The signal may be weak inside buildings.
Take the product outside or place it on a window sill.
2. The windscreen has UV protection which weakens the signal.
Take the product outside or place it on a window sill.
If the signal is still weak, set the clock manually. When you have set
the clock manually, the product will continue to search for a radio
signal. The time will be updated next time a sufficiently strong signal
is picked up.
If the product cannot be attached to the windscreen, it may be because:
1. The windscreen is dirty. Clean the windscreen thoroughly with
Isopropyl alcohol or acetone.
2. The windscreen is too cold. Warm up the windscreen and try again.
If you need to change the windscreen or if the product is to be moved from
one car to another, blow hot air on the outside of the windscreen with e.g.
a hairdryer before removing the product. This makes it easier to release
the product and ensures that no marks from the adhesive pads remain.
Go to www.jjpd.dk for further information.
Registers when the car is started, is being driven and is being parked
The technology in the Electronic Parking Disc automatically registers when
the car is started, is being driven and is being parked. In this way, the product
is always able precisely to register when the car is parked.