Jackson CONSERVER XL2C, Инструкция по установке, эксплуатации и обслуживанию, Страница: 31 / 54

07610-002-10-23-V
24
OBSERVATION POSSIBLE CAUSE REMEDY
Machine will not fill, other
functions work.
1. Y-strainer plugged.
2. Water valve turned off.
3. Faulty solenoid valve
diaphragm.
4. Faulty solenoid coil.
5. Faulty fill microswitch.
6. Faulty OFF/ON/FILL switch.
1. Clean strainer.
2. Turn on water valve.
3. Replace diaphragm, clean foreign material out of valve body
and orifices.
4. If coil has voltage but no continuity, replace coil (continuity is
measured across coil connectors with wires removed).
5. Will not fill during cycle only. During fill, measure between the
ORANGE and WHITE/GREEN wires. If 120 V, adjust or
replace switch.
6. Depress switch, measure between BLACK and WHITE/
GREEN wire. If 120 V, replace switch.
Machine fills continuously,
only when the power is on.
1. Faulty fill microswitch.
2. Cam timer stalled in fill
position.
3. Shorted OFF/ON/FILL switch.
1. Repair/replace switch.
2. If cam timer is not rotating, check the voltage to the timer
motor. If 120V when door is closed, replace the timer motor.
3. Check voltage between BLACK and WHITE/GREEN
connections of the switch in the "ON" position. If you do not
read 120 V, replace switch.
Wash motor does not run.
Other functions work, but the
wash motor runs only when
the wash relay is manually
pushed down.
1. Faulty control relay.
2. Faulty wash relay. 1. Check the voltage across relay contacts #7 and #4. If 120 V
during the wash cycle, replace the relay.
2. Check voltage at relay coil between ORANGE/BLACK and
WHITE wires. If you read 120 V, coil is faulty. Replace the
relay.
Wash motor does not run
even when the wash relay is
manually depressed; other
functions work.
1. Loose wire connections to
motor, delime switch, or from
contactors.
2. Mechanical binding in pump.
3. Faulty wash motor.
4. Faulty wash relay.
5. High or low voltage problem.
1. Tighten wires.
2. On end of motor, opposite pump, remove endcap. With large
slot type screwdriver, fit into slot in end of shaft. Turn to
dislodge. Run motor as normal. If it still does not run, replace
motor.
3. If the motor has the correct incoming voltage and the pump is
okay, replace the motor.
4. With the wash relay pushed in, check the voltage between T1
and L1 of the relay. If 120 V, replace the relays.
5. Check voltage at motor and at power terminal block. Compare
to electrical specifications.
Wash motor runs
continuously.
1. The NORMAL/DELIME switch
is in the Delime position.
2. Wash relay contacts are
welded closed.
3. Cam timer stalled in wash or
rinse cycle.
4. Wash motor microswitch faulty.
1. Place the switch in the Normal position.
2. Turn machine off. If wash relay doesn't release, replace
contactor.
3. If cam timer is not rotating, check the voltage to the timer
motor. If no voltage when the door is closed, check wires and/
or replace motor.
4. Tighten connections, make sure switch makes contact, replace
if necessary.
Machine will not hold water. 1. Faulty drain ball.
2. Obstructed drain hole.
3. Drain linkage is binding.
1. Replace drain ball.
2. Clear obstruction.
3. Repair drain mechanism parts.
TROUBLESHOOTING
TROUBLESHOOTING