Jackson Systems T-32-TS Touchscreen Thermostat, Руководство по установке

Страница: 9 / 63

INSTALLING THE THERMOSTAT
hole to prevent any drafts that might affect the internal temperature sensor. Pull the
control wires through the large opening in the thermostat subbase. Next, level and
mount the subbase on the wall using the supplied anchors and screws. (Figure 2)
Do not over tighten the mounting screws as the subbase may warp causing the
improper seating of the thermostat connecting pins to the terminal blocks.
Use a properly sized screwdriver
and back each screw terminal out
(counter clockwise) before
landing each wire to its dedicated
terminal. Do not over tighten the
terminal screws. Check to ensure
that all wires are landed correctly
and dressed properly to prevent
any shorts. Refer to Typical System
Wiring Diagrams in this manual
for proper wiring.
FIGURE 2
7
S2 SC S1O/BW1
Y1 Y2 G R C
Jackson Systems, LLC
www.jacksonsystems.com
WIRE
ACCESS
HOLE
BATTERY
COMPARTMENT
MOUNTING HOLES
MOUNTING
HOLE
MOUNTING HOLES
W2