Jackson MSC 10AB-N70, Инструкция по установке и эксплуатации

Страница: 65 / 116

I-980 Page 4 of 8
Rev. E-35763 6/10/10
Installation
WARNING: INSTALLATION OF DEMA PRODUCTS MUST MEET ALL APPLICABLE
ELECTRICAL CODES AND REGULATIONS ESTABLISHED BY NATIONAL, CITY,
COUNTY, PARISH, PROVINCIAL OR OTHER AGENCIES. IT IS POSSIBLE THAT
ELECTRICAL CODES AND REGULATIONS REQUIRE THAT A CERTIFIED
ELECTRICAL CONTRACTOR OR ENGINEER PERFORM THE ELECTRICAL
INSTALLATION. FOR QUESTIONS, CONTACT A CERTIFIED ELECTRICIAN.
ALL ELECTRICAL POWER MUST BE TURNED OFF TO THE HEATING ELEMENTS AND DISH
MACHINE PRIOR TO BEGINNING INSTALLATION
UNIT MUST BE GROUNDED (EARTHED).
Mounting the Nitro
1. Remove mounting bracket from dispenser.
2. Mount the bracket in an appropriate place on a wall.
3. Slide the dispenser onto the bracket and attach the secure screw on the bottom left corner of the dispenser.
Setting up the Nitro and the Dish Machine
1. Locate the electrical connection point. The input power may be 100V – 265 V 50/60 Hz. Check with the
manufacturer of the machine to determine if there are dedicated terminals available for installation.
2. Properly ground the dispenser to earth ground.
3. If the Nitro will be operating in the concentration mode, locate the proper position for the DEMA C-12B probe
or the DEMA Inductive Probe (82.28.1) in the wash tank. The probe must be installed below the water level,
normally 1-2” from the bottom of the tank, and must be kept away from heating elements, pump intake, drains
and incoming water supply.
4. Install the detergent injection bulkhead fitting (80-55) above the probe (if a probe is used) to obtain a rapid
reading of all chemicals entering the wash tank.
5. Install the rinse line injection fitting (904-8T) into the rinse line tap provided by the manufacturer of the
machine. If a tap is not provided, follow the manufacturer’s recommendations for installing this fitting.
6. Install the sanitizer injection fitting (904-8KY) (if sanitizer is used) into the rinse line tap provided by the
manufacturer of the machine. If a tap is not provided follow the manufacturer’s recommendations for installing
this fitting.
Connecting the Chemical Tubing to the Nitro
1. After mounting the dispenser, measure the length of tubing needed to go from the dispenser to the chemical
containers. The detergent tubing (25.68.20) is opaque in color and has a larger inside diameter than the rinse
and sanitizer tubing (100.12.SV1) which is clear in color and has a small inside diameter.
2. Cut the tubing to the length required and, if desired, place the pickup tube on the tubing before placing in the
chemical container.
3. Measure the length of tubing needed to go from the dispenser to the chemical injection point on the machine.
4. Cut the tubing to the length required to reach the bulkhead fitting or chemical injection point on the machine.
Clasp Close Pump Heads
The pump heads have an added feature which will
help to ensure the pump head is installed properly.
When pushing the pump head on be sure to see the
clip is fully covering the notch as seen in the first
picture. If the tab is not fully engaged, there is a
possibility of it popping off the pump head as seen in
the second picture.
Wiring the Nitro to the Dish Machine
The following diagram is included to help to install the wires in the correct places for proper power for the unit.
WARNING: For safety purposes disconnect main power to the dish machine before wiring
trigger signals to the Nitro. Connect power to the Nitro per the dish machine manufacturer’s
recommendations.
UNIT MUST BE GROUNDED (EARTHED).