Jackson MSC 10AB-N70, Инструкция по установке и эксплуатации

Страница: 33 / 116

Technical Manual (07610-003-97-40)
SERVICE INSTRUCTIONS FOR INCOMING WATER SOLENOID VALVE
28
Page Created: 09-10-2012
Revised: N/A
DIAPHRAGM CARTRIDGE
POSSIBLE PROBLEMS:
Pilot port extension #1 clogged, hole #2 clogged.
REMEDY
Pass heated straight pin through hole #2 or clean
hole #1.
DISASSEMBLY: The valve may be taken apart by unscrewing the valve bonnet from the valve body. After
unscrewing, carefully lift off the valve bonnet. Do not drop the plunger. The o-ring and diaphragm can now be
lifted out.
BE CAREFUL NOT TO DAMAGE THE MACHINED FACES WHILE THE VALVE IS APART.
TO REASSEMBLE:
Place the diaphragm in the valve body with the pilot port extension up. Hold the plunger
with the synthetic seal against the pilot port. Make sure the o-ring is in place, then lower the valve bonnet over
the plunger. Screw valve bonnet down on the valve body.
Screw
Data Plate
Coil & Housing
Valve Bonnet
Spring & Plunger Kit
06401-003-07-40
Diaphragm
Retainer
O-Ring & Diaphragm Kit
3/4” Kit
06401-003-07-42
Screen
Retainer
Mesh Screen
Valve Body
110 Volt 3/4” Solenoid Valve Assembly
04810-200-01-18
Coil & Housing only
04810-100-53-00
240 Volt 1/2” Solenoid Valve Assembly
04810-100-09-18
Coil & Housing only
06401-003-07-43
3/4”Vacuum Breaker Assembly
04820-002-53-77
06401-003-06-24
Cap Screw
Data Plate
Cap
O-Ring
Plunger
Body
Cap Retainer
1
2
TO TAKE THE SOLENOID VALVE APART
DISASSEMBLY - These valves may be t aken ap art by
unscrewing the bonnet and the enclosing tube assembly from
the valve body assembly. After unscrewing, carefully lift off the
bonnet and enclosing tube assembly
. Don’t drop the plunger .
The o-ring seal and diaphragm cartridge can now be lifted out.
Be careful not to damage the machined faces while the valve
is apart.
TO REASSEMBLE - Place the diaphragm cartridge in the
body with the pilot port extension UP. Hold the plunger with the
synthetic seat against the pilot port. Make sure the o-ring is in
place, then lower the bonnet and enclosing tube assembly
over the plunger. Screw the bonnet assembly snugly down on
the body assembly.
Possible Problems:
1. Pilot port extension #1 clogged. Clean hole.
2. Hole #2 Clogged. Pass heated straight pin through hole.
½” Vacuum Breaker Assembly
04820-003-06-13
110 Volt 1/2” Solenoid Valve Assembly
04810-100-12-18
Coil & Housing only
06401-003-07-43
240 Volt 3/4” Solenoid Valve Assembly
04810-200-02-18
Coil & Housing only
04810-100-03-18
½” Kit
06401-003-07-41
Components of Repair Kit 1/2”
06401-003-06-23
Components of Repair Kit 3/4”