6
or lightning rod. It cannot be replaced with the neutral wire of single-phase power.
In addition to the ground wire, an electrical leakage circuit breaker is also required.
Consult a qualified electrician if you do not completely understand these
grounding instructions.
DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD
(GROUND) PRONG FROM THE POWER CORD.
If installation in a damp location is unavoidable, have an electrician install a
ground fault circuit interrupter (GFCI) electrical outlet. If no GFCI is installed,
electrical shock could result.
Do Not Use an Extension Cord
Avoid the use of an extension cord because of potential safety hazards under
certain conditions.
Operating Your Beverage Center
IMPORTANT: Do not plug in the Beverage Center for 24 hours after unit is set in
place. Failure to do so may result in the unit working improperly.
Compartment Design
The SC90OD Beverage Center has a capacity of 28 standard wine bottles or 84
cans. The unit has 3 adjustable chrome-plated flat wire shelves and a wire basket
to hold cans and bottles of beverages such as beer, water and soft drinks.
This
design enables you to operate the unit as a Beverage Center or wine cellar. The
control panel also allows you to set a different temperature for Beverage Center or
wine cellar. The control panel displays the current temperature inside the
compartment and allows you to turn the interior light on and off.
OPERATING INSTRUCTIONS
Turning On the Unit
The Beverage Center turns on automatically when it is plugged in. The unit
employs a heater inside the cabinet and is designed for outdoor use. When the air
temperature is below
4
º
C (40°F)
, the compressor will stop working and the heater
will work automatically to maintain the temperature setting. If the Ambient
temperature is below
-4
º
C
(25°F)
, do not use the unit to storage anything.
