JackaJay USER GUIDE
14
function and all checks have been completed. When the user is
satisfied, press the blue ACCEPT button.
The controller will then enter the Automatic function mode and will
continue until it completes the requested operation or detects a
Fault, (see 4.3 Fault detection)
During the Automatic operation, the user will be notified when
each corner reaches it’s Lift or Lower points. Once all 4 corners
provide feedback, that operation is complete.
During the Automatic function phase, please ensure that all operations are
unhindered, canvas is loose and not caught on any obstructions and the middle
telescopic mast section is loose and centred.
Damage may occur if monitoring / precautions are not undertaken.
Please be aware that each corner may experience heavier loads due to
roof design or roof additions. This may cause different corners to lift or lower
at different rates. However, it is not an issue if the controller is still operating
and each corner is moving. In the event that a Fault or issue is detected, all
operations will halt.
4.2.2.1 Stopping the Automatic Operation
If during the Automatic operation you would like to halt
all movement, press the red STOP button.
To make any further operations, press the blue BACK
button to take you back to the HOME page and select
your desired operation.
