18
19
TROUBLESHOOTING
• Check if unit is plugged in.
• Check if Locking Bar is locked in place properly.
• Check if all parts are assembled properly.
• Check if there is any residue left between Blade
and Receptacle.
• Check if all parts are assembled properly
and in the correct position.
• Juicing overripe fruit may result in too much
pulp and will clog the Filter. Turn machine off
and clean the Filter.
• Too much pressure may have been applied
with the Pusher while processing causing the
motor to accidentally overheat. Power down,
disassemble, clean and allow to cool; see page 4.
• Juicing overripe fruit may result in too much
pulp and will clog the Filter. Turn machine off
and clean the Filter.
• Make sure the Juice Spout is in the downward
position while juicing. If it is in the upward
position the juice will not come out.
It will overflow from the sides of the Receptacle.
• Lubricant burn-off may occur during first use
but should go away thereafter.
• Too much pressure may have been applied
with the Pusher while processing causing the
motor to accidentally overheat. Power down,
disassemble, clean and allow to cool; see page 4.
• Make sure the Juice Spout is in the downward
position while juicing.
• Push gently with the Pusher. Pushing too hard
may cause the juice to come out of the side of
the Receptacle.
The motor does not
run after being
switched on.
The motor is running
with a loud noise and
excessive vibration.
The motor overheats
causing the power
to automatically
shut off.
Juice is coming
out of the side of
the receptacle.
No juice is coming
out of the Spout.
Juicer is Burning or
Smoking.
Problem
Possible Reasons and Solution
