11
The motor does
not run after being
switched on.
The motor is running
with a loud noise and
excessive vibration.
The motor overheats
causing the power to
automatically shut off.
Juice splashes from the
rim of the receptacle.
• Check to see if unit is plugged in.
• Locking Bar is not locked in place properly.
• Check if all parts are assembled properly.
• Check if there is any residue left between
Blade and Receptacle.
• Make sure you wait 5-10 minutes to restart
if machine automatically shuts down.
• Check that all parts are assembled properly
and in the correct position.
• Juicing overripe fruit may result in too much
pulp and will clog the Filter. Turn machine off
and clean the Filter.
• You may have applied too much pressure with
the Pusher while processing causing the motor
to accidentally over heat. This activates the
built-in Thermal Cut Off Switch. The motor
will temporarily stop working for
approximately 10 minutes to cool down. See
additional information on page 5.
• The motor needs to warm up for 5–10 seconds
before first use.
• The fruits and vegetables may be soft
or overripe.
• There may be too much pulp in the Filter.
Turn machine off and clean the Filter.
• This is normal.
TROUBLESHOOTING
Problem
Possible Reasons and Solution
The motor is running.
The spout is in the
downward position,
but no juice is
coming out.
•
Turn the power off and unplug the machine.
Wait for blade to stop spinning. Use a
toothpick to loosen any obstruction in the
non-drip spout.
