JAC HFC1035KD, Руководство пользователя

Страница: 62 / 80

3. Apply a thin layer of engine oil to the O ring surface. Place the O ring in, and
take care not to have the fuel overflow while tighten it slowly inside the filter,
until it sits firmly against the sealing surface.
Afterwards, further tighten the filter by 2/3 round with a filter spanner.
4. Operate the handle of the manual pump on the oil/water separator for sever 鄄
al times to vent the fuel system.
5. After the fuel filter is vented, start the engine with the start switch.
6. If the engine fails to start within 10 seconds, vent the system again.
118
OWNER 爷 S MANUAL
JAC High end Light Trucks
Engine cooling water
To change the cooling water, loosen the discharge valves on the radiator and
cylinder block to drain the water out of the cooling system.
The engine cooling system should be washed at least once a year, to ensure
the best cooling effect.
JAC recommends use of anti-freezing fluids without any content of rust pre
鄄
ventive and other additives.
Valve clearance adjustment
1. Turn the crankshaft until the top dead center on the crankshaft pulley is in
alignment with the timing mark, to have the piston in the first or the fourth
cylinder move to the top dead center of the compression stroke.
119