JAC HFC1035KD, Руководство пользователя

Страница: 61 / 80

Wheel cylinder
Venting screw
Locknut
Adjusting nut
Clutch shifter
Master cylinder
Pedal adjusting bolt
Adjusting nut, tightening 1.5~2.5kg.m
3. Filter element treatment
Cleaning of the filter element is done in one of the following methods depen 鄄
dent on its contamination.
The filter element is dust contaminated but still dry:
Turning the element with hand, and blow off the dust from its inside with com
鄄
pressed air, whose pressure should be below 7kg/cm2.
Clutch pedal adjustment
1. Loosen the blocking bolt or the clutch switch, and adjust the clutch pedal
height to the specified value. 2. Loosen the locknut and adjusting nut of the
follow-up cylinder. Screw down the adjusting nut until it contacts the clutch shift
fork, and then screw it back for one and a half round.
3. Tighten the locknut.
4. Adjust the pushrod length of the master cylinder, to bring the backlash of the
clutch pedal up to the specified value (this needn't be done in trucks provided
with servo mechanism).
5. Adjust the clutch switch gap (L), to keep it within 0.5-1.0mm.
116
OWNER 爷 S MANUAL
JAC High end Light Trucks
Clutch pedal backlash and standard height
(1) Backlash: 15-25mm
(2) Height: 205-213mm
Fuel filter
1. Loosen the filter counterclockwise with a filter spanner.
2. Clean the mating surface of the filter bonnet with a piece of cloth, in order to
have the filter installed firmly on the mating surface.
117