JABSCO Hy-Line, Инструкция по установке, эксплуатации, техническому обслуживанию и запасным частям

Страница: 7 / 52

All
Hy~Line
and
Ultima
pumps are equally
suitable for both directions of rotation.
Hy~Line
and
Ultima
lobe (not LH32 or
LH34) pumps can be rotated to give vertical
or horizontal port orientation with high/low or
left/right input shaft positions. This is
achieved with the bolt-on feet and
re-positionable gear cover. (see Figure 2)
To change any pump from vertical to
horizontal pipework or vice versa, a
conversion kit containing the required feet
and other components is available.
To convert a pump from high shaft to low
shaft, it is necessary only to reverse the feet
and timing gear cover positions as follows:-
Foot Change
Remove key (29) from the drive shaft end.
Remove the 2 bolts (18) from the gear cover
(11) and slide the cover off of the shaft end,
being careful not to damage the inside of the
lip seal on the edges of the keyway in the
shaft. Rotate the cover to the desired
position and re-fit. It is wise to fit new sealing
washers (19) to the heads of the bolts
before re-fitting. Remove the 4 retaining
screws (21) from the feet and re-position the
feet in the desired position. Re-fit the bolts.
For LH72, 74, 76 Pumps - Replacement
feet for vertical seal.
For LH32 and LH34 Pumps:
The LH32 and LH34 size pumps are factory
built with HORIZONTAL PORT orientation
with top shaft position. They cannot be
modified for alternative mountings. To
enable VERTICAL PORT orientation it will
be necessary to mount the pump on an
angle bracket (‘L’-Bracket). A special gear
cover will be required.
Page 5
Hy~Line
and
Ultima
Lobe Pumps
07/03
Horizontal Pipe Orientation,
high drive shaft position
Horizontal Pipe Orientation,
low shaft drive position
Vertical pipe orientation
Figure 2