JABSCO Hy-Line, Инструкция по установке, эксплуатации, техническому обслуживанию и запасным частям

Страница: 5 / 52

Hy~Line
and
Ultima
pumps can be used for
duties other than those for which each pump
was originally selected but the new
application must be checked against the
Performance Data Sheet to ensure safe and
reliable operation. Unless you have
experience in the use of this Data Sheet, we
strongly recommend that, if a change of duty
is required, you contact the distributor who
supplied the unit or the manufacturer.
Change of duty means changing any of the
parameters listed above.
1.04 MODEL NUMBERING SYSTEM
A metal plate is fixed to the pump showing
model number and serial number.
The MODEL NUMBER gives important
information about the specification of the
pump, see Section 8 for details. It is
important that the pump specification is
established using Section 8 before any work
is carried out on the pump or parts are
ordered.
The SERIAL NUMBER is unique to each
pump.
Both numbers should be quoted with all
queries or orders for spares.
1.05 INSPECTION UPON RECEIPT
All
Hy~Line
and
Ultima
pumps are factory
inspected and tested before packing and
shipping, to ensure safe delivery and
satisfactory service. We would, however,
recommend that you carry out the following
actions upon receipt of your lobe pump:-
a) Remove packing material from
container and check contents against
packing list. Look carefully for small
parts and special tools included.
b) Check the pump for any physical
damage sustained in shipping. If loss
or damage is found, notify your
carrier and supplier immediately.
c) Use lifting equipment as necessary
when unpacking heavy items. See
Performance Data Sheet for weights
of bareshaft pumps. Drives and
baseplates will increase weight
above those shown.
Page 3
Hy~Line
and
Ultima
Lobe Pumps
07/03