JABO 2AG, Руководство пользователя, Страница: 9 / 14

9
es After nesting the boat, you only need to op en the hatch cover (don
’
t pull out the
plugs that have been inserted), an d connect the battery plug to the power socket insid
e the boat. When co nnecting, pay special attention to the polarity of the battery and
the reve rse connection. It will burn out the receiver and motor drive board. The corr
ect connection method is to insert the red wire of the plug to the red wire of the soc
ket and the black wire to the black wire. After the plug is connected, cover the cabin.
The remote control battery has been placed in the remote control before leaving the fa
ctory
2
Function Test: Before the boat is launched into the water, functional testing is required.

Power on: Put the nesting boat in a stable place, then turn on the power switch on the hatch
cover, the two tail lights start to flash, indicating that the receiver is energized normally.

Turn on the power switch of the remote control, the tail light changes from flashing to off,
and the remote control and the receiver are successfully coded. In order to be able to use
multiple boats at the same venue at the same time, an address code (serial number) is set in
the remote control circuit. The serial number of the remote control at the factory defaults to
"000". When the boat is turned on, the receiver will first receive the address code (serial
number) of the remote control. Once the code is completed, as long as the power switch of
the boat is not turned off, the small boat will receive the control commands of the remote
control that it is paired with. In this way, multiple boats can be operated on the same site
without affecting each other. It should be noted that every time the boat turns on the power
switch, there will be a code matching process.

Forward: Push the handle of the remote control forward and the two motors of the boat start
to rotate. The left and right direction lights are always on. At this point the boat is in progress.

Left turn; Turn right: Push the remote control handle to the left or right to make a left turn for
the boat (right side of the motor is turning, the left side of the motor isreversed, the left
direction light is blinking), turn right (left The side motor rotates forward, the right motor
reverses, and the right direction light flashes).

Back: pull down the handle of the remote controller. The two motors rotate in opposite
directions. The left and right lights flash, and the boat is back.

Lure fish light function: Press the lure switch on the remote control to turn on the lure light at
the bottom of the boat and press the lure light button again to turn off the lure light. Float
light status indicator on the LCD screen can show the status of the current lure light
。

Sonar detection function: This function works properly in open natural waters. A false
detection result will be obtained in the air or in the bathtub or swimming pool. The
sonar sensitivity is set at 50% at the factory. It is suitable for use in waters with a depth
of 2-10 meters. If the water depth is deeper, the sensitivity of the sonar sensor should be
increased. . (sensitivity adjustment range 1-99%)

Yaw adjustment: As the JABO2BG type wrecking boat is driven by dual motors, the
rotation speed of the two motors and the transmission error of the mechanical
transmission shaft system cannot be completely consistent, and the yaw phenomenon
may occur during use. For this yaw, Adjust by calling the yaw adjustment menu of the
remote control. .
It should be noted that here, the electronic yaw adjustment function is designed to