JABO 2AG, Руководство пользователя, Страница: 4 / 14

4
Figure 1 shows the remote control:
How to use the remote control: First turn on the boat
’
s power switch, after the two tail lights
flash, operate the remote control as shown in the following table:
JABO
Press and hold the power button for 2 seconds. The screen
enters the boot page. The "JABO" welcome page appears
first.
Compass Cal
Y N
Calibration: Compass calibration is required for the initial
use of a boat or to a distant water surface (if the compass has
been calibrated on the water surface)
You can select “N”, no more compass calibration, directly
enter the starting point of setting.) Press “Left ” key, select
“Y”, then press “S” key to confirm.
5m off shore
Next
"5 moffshore" appears: first use the operating handle to drive the ship
5-10 meters away from the shore, and then press the "S" key to enter
the compass calibration function.
Compass Left
"Compass left" , the boat will automatically turn left, and
the display will change from 0 to 360 degrees. When the boat
turns left for 2 weeks, press the "S" key again,
Compass Right
"Compass right", the boat starts to turn right automatically,
the display changes from 0-360 degrees, when the boat turns
right for 2 weeks, press the "S" key again
Cal save
Y N
“Cal Save” . By default, “Y” is selected. After pressing the “S” key, the
compass calibration is completed and the calibrated compass data is
saved.
GPS set start
Y N
It is very important to set the GPS starting point, and you
need to determine the GPS starting point each time you use
it. If you do not determine the GPS starting point, you will
not be able to return to the boat. This item is "Y". After the
GPS starting point is established, the “*” symbol appears on
the LCD screen to represent the starting point.