JABO 2AG, Руководство пользователя, Страница: 5 / 14

5
Note: Compass calibration is required only when first used or when changing to another venue. The second
time it is used on the same site, you can directly select “N” on the Compass Calibration page to enter the
“Set GPS Origin” page.
It should be noted that it takes 2-5 minutes for the boat
’
s receiver to establish a connection
with the satellite system. If the boot time is too short, the connection with the GPS has not
been established. After selecting "Y", no "*" appears on the LCD screen. , It means that the
starting point has not been established, you need to wait 2-5 minutes, and then select "Y"
until the starting point is established. If the starting point cannot be established for a long
time, you can press the N key to enter the navigation setting page and select "Set start ":
press the "S" key to set the start point and complete the start point setting.
After setting the starting point, enter the navigation operation interface:
The first row of icons from the left are:
1 Signal strength; 2 Remote control battery power; 3 Boat battery
power; 4 Driving status indication; 5 Satellite icon;
E is the longitude coordinate;
N is the latitude coordinate
Turn on the boat switch first, and then turn on the remote control
switch, the first "*" on the left indicates that the navigation module
has started to work.Before fully establishing contact with the
navigation satellite, the latitude and longitude coordinates display a
series of "X", at this time the "X" has no meaning. After the boat has established a connection
with the satellite, the values of E and N are the boat satellite positioning coordinates.
After setting the starting point, enter the operation page, and you can start to operate
the nest boat with the operation handle.
Parameter setting: After entering the operation page, press the setting key "S",
the screen enters the parameter setting page.
Sensitivity
50
“
Sensitivity” can be adjusted between 01-99. The higher the
sensitivity is, the better. If the sensitivity is too high, it will amplify
interference signals and display invalid data. The factory default is
"50", which is suitable for water depths of 1.8-10 meters.
SerialNumber
000
“Serial Number” is the code of the remote control. Remote controls
with different codes are used in the same venue without interfering
with each other. 0-250 can be set. Factory default "000"
Temp,Unit
º
F
Temperature units are divided into Celsius and Fahrenheit
Length Unit
Ft
Length Unit: Meter, Feet
Beep
ON
This is a key tone, which can be selected on or off
Backlight
ON
LCD backlight, optional on or off