Specifications:
J3
–
H85
Materials of construction:
The
J3
- H85 electric rotary actuator
Model
J3
– H85 Electric Actuator
Visual indication of the
actuator’s operating
status is constantly
shown by a highly
visible LED light.
J3
Voltage range - automatically sensed by actuator
85-240 AC (1ph) or DC
Operating time (0-90° no load)
30 seconds
Maximum break torque
93.5 Nm / 827 lb.ins
Maximum operating torque (run/ reseat)
85 Nm / 752 lb.ins
Duty rating
75%
IP Rating (IEC 60529)
IP65
Working angle Standard (on request)
90° (180° or 270° options)
Mounting ISO:5211 x DIN 3337
F05 & F07 x 17
Motor switches
2 x SPDT micro switches
End of travel confirmation (volt free)
2 x SPDT micro switches
Heater
4 W
Ambient temperature range
-20° to +70°C -4 to +158°F
Electrical connecting plugs
DIN 43650/ ISO4400 & C192
Consumption:
240V/1ph At maximum torque
0.09A
240V DC At maximum torque
0.10A
110V/ 1ph At maximum torque
0.22A
110V DC At maximum torque
0.17A
Weight
3.0 kg
Housing
Anti-corrosive Polyamide
Fasteners
Stainless steel
Gears
Polyamide (speed reducing) & steel
Shaft
Stainless steel
Output drive
Zammac
Position indicator
Glass filled Polyamide
Method of operation:
On receipt of a continuous power signal within the voltage range shown above, the motor in the J3
electric actuator runs and, via a flat gear system, rotates the output shaft. The motor is stopped by
internal cams striking micro switches. On receipt of a reversing continuous signal, the motor turns in
the opposite direction reversing the output drive.
Note: The power signal needs to remain on at all times to activate the thermostatic anti-condensation
heater. The volt free end of travel confirmation switches must NOT be used to cut the power. As they
are set ahead of the final motor stop position, cutting the power on receipt of the end of travel signal
will result in the J3 electric actuator stopping short of the full open or full closed position determined
by the motor switch settings.
