Step 4:
Align the hole of the pedal (5-1, 5-2) to the pedal bracket. Use flat washer (12), screw M8X15 (11) to tighten the pedal.
The screws are located in the arm, please unscrew washer and screw from the arm and re-attach pedals to the arm with
these screws. Place the pedal with
the arrows that indicate stand up and sit down. The sticker should be on the
inside close to the tension knob and the top carry handle, with the “sit” arrow pointing towards the rolling bar and the
“stand” arrow pointing towards the plate handle. Match the other foot plate to be sure that it is facing the same direction
with the round toe section of the foot pedal close to the rolling bar, and the flat end of the foot pedal close to the plate
handle as shown in the diagram below. This will insure that your pedals are facing the correct direction.
IMPORTANT!
Wheels tend to be “squeaky” upon initial use. Please use a small amount of lubricant provided or some WD40 between the
wheels and the base plate to eliminate the squeak. We use extra large roller blade wheels for longer wear and smoother ride
yet they tend to be squeaky, a little lubricant will eliminate the noise.
