J.E. Adams 8670-5WB, Руководство пользователя

Страница: 12 / 22

8670-5WB Manual – 10/2006 12
Figure 6: IDX timer setup
Figure 6 shows an IDX timer set for 3 coins to start and 60 seconds per coin
for a total run time of 3 minutes.
TIMER SETUP – IDX TIMERS
Note: IDX timers are accumulating timers. During use, timing can be
extended proportionately by adding more coins.
The IDX timer has two adjustable settings: Time per coin (in seconds)
and number of coins to start.
Time per coin:
Time per coin
is the amount of time the unit will run per coin inserted
and can be set from 2 seconds to 510 seconds (8.5 minutes) in increments
of 2 seconds by turning on the correct switches until their values equal the
desired time
. Refer to Tables 1 and 2 (pages 14-15) for standard timer
and coin settings (Note: IDX timers do not have 1 second or 512 second
switches. When configuring timer using Table 1, ignore settings for
switches 1 and 512)
. For custom settings, follow the steps below:
1. Figure the total time your vac will run (in seconds) and divide that
number by the number of
coins to start . This is your time per coin .
Round up or down to the nearest even number.
2. Subtract the largest value switch (initially 256) from your time per
coin .
a. If the resulting number is zero , move the switch to the “on”
position and set all remaining un-set switches in the “off”
position. Your timer is now set.
b. If the resulting number is positive , move the switch into the
“on” position. Using the resulting number as your new time
per coin , repeat step 2 with the next largest switch value.
c. If the resulting number is negative , set the switch in the “off”
position and repeat step 2 using the next largest switch value.
Coins to start:
Coins to start is the amount of coins needed to activate the timer and can
be set from one to seven coins in increments of one coin. Refer to Table
1 (page 14) for switch settings.