J.E. Adams 8670-5WB, Руководство пользователя

Страница: 16 / 22

8670-5WB Manual – 10/2006 16
PROGRAMMING THE REMOTE START SYSTEM
Note: The remote start system will need to be re-programmed each time the unit is powered up.
1. Remove cover from signal receiver by pressing in at the center of each of the two lengthwise
sides.
2. Locate the covered Learn Code Button and LED indicator at the top of the circuit board. They
will be located directly beneath the upper tab holding the circuit board in place.
3. Press and release the Learn Code Button. LED indicator will blink at a rate of two times per
second.
4. Press the Transmitter Button once. The indicator light should now be on continuously.
5. Press the same Transmitter Button again. The indicator light should now turn off. The remote
start system should now be programmed.
Note: You must perform steps 3-5 within 30 seconds.
If the LED indicator begins to blink rapidly (about 4 times per second) you must repeat steps
3-5.
6. Test the system to verify proper operation.
7. Replace cover, making sure antenna is hanging straight down outside the cover.