IXXAT CAN@net NT 200, Руководство пользователя

Страница: 19 / 34

Configuration 17 (32)
► To identify the connected devices and the firmware version, open menu Scan and select All
Ixxat devices .
→ Connected devices and firmware version of the devices are shown.
→ Devices that are connected via a router are not found. IP address and device firmware
version must be known.
→ Devices with an unknown or invalid IP address are not found (for more information see
Scanning for Devices with Unknown IP Addresses, p. 18 ).
► If the connected device is not found, see Scanning for Devices with Unknown IP Addresses, p.
18 for more information.
► Select the type of CAN@net NT in use in drop-down list Select device type ( 2 ).
► Select the firmware version of the device in drop-down list Select device version ( 3 ).
► Select the desired operational mode for the device in use in drop-down list Select
operational mode ( 4 ).
►
Click button Scan ( 10 ) and select the device in use in combo box Target Device ( 11 ).
or
If the device is connected via a router, enter the IP address (see Default Network Settings, p.
27 ) in combo box Target Device ( 11 ).
► Click button Connect ( 12 ) to connect the selected device.
► For ASCII Gateway and VCI Interface mode make sure that the IP address is in the range of
the network in which the device is integrated (see
Changing IP Address and Device Name, p.
19 ).
► For CAN-Ethernet-CAN bridge make sure that the IP addresses of all devices of the bridge
are in the same IP range (see
Changing IP Address and Device Name, p. 19 ).
► To create a new project file, click button New ( 5 ).
or
To change an existing configuration, click button Read from ( 14 ) and save the configuration.
►
Configure the device in the selected mode (see Configuration of Interface Modes (ASCII, VCI,
ECI), p. 20 or Configuration of Bridge Modes (Local CAN, CAN-Eth-CAN), p. 21 ).
CAN@net NT User Manual 4.01.0332.20000 1.7 en-US