IXXAT CAN@net II/Generic, Руководство пользователя

Страница: 15 / 40

CAN@net II/Generic, Version 1.5
ASCII Protocol Server
15
Commands:
Command Parameters Description
VER -
Device issues an info message which
contains the firmware version information
e.g.
“I CAN_at_net_II_ZZ_YY, FW V2.01.02,
HW V1.4, SerNo HWxxxxxx”
ZZ and YY are the last 2 bytes of the
device MAC address. HWxxxxxx is the
HW serial number.
PROTO -
Device issues an info message which
contains supported protocol version
information e.g.
“I ASCII Extended Protocol V1.1”
CONFIG
SAVE
-
Stores the actual setting of the filter into
the flash. The filter settings are loaded
after a device reset or power on.
RESET - Device reset
Table 4.2.2 Device commands
All messages of type "Device command" are answered by the ASCII-Protocol
server with either an error message (see 4.2.5) or the requested information
packed in an Info message (see 0).
Figure 4-2 Device Command Request/Response Cycle
It is good practice to issue Device commands to the ASCII-Protocol server only
one at a time and then wait for the response. As some commands may take
longer to be processed than others, the timing of the response messages may
vary. So the sequence of responses to commands which were issued in a row
may be changed. And the ASCII-Protocol provides no mechanism (like message
identifiers) to match commands to their responses.
CAN@net II/
Generic
(Server)
Device Command
Error or Info message