5.1.2
Opening the ramp
1.
Position the trailer on firm level ground and apply the vehicle and trailer handbrake.
2.
Lower the rear prop stands if fitted.
Caution.
If the trailer is facing up hill, nose up, when opening the rear ramp, the ramp may start to
drop as soon as the catches are released.
3.
Before opening the ramp look inside for anything leaning against the ramp and remove if
possible.
4.
Unlatch each side of the ramp in turn as follows:
i)
Whilst holding the
latch arm stationary
pull back the shoot
bolt and latch it in
the retracted
position.
ii)
Keeping a firm hold, push away and lift
the latch arm to unhook it from the
ramp keep.
iii)
Move the latch arm away from the ramp
by 10cm. (4 inch)
•
If the arm is still pushing
towards you at this point
push it back and latch it
back into place, and stop to
investigate inside the box
for a load pushing against
the ramp.
•
If there is no load on the
latch arm continue.
iv)
Rotate the latch arm away from the
ramp and make sure you are to one
side of the ramp as you do this.
v)
Allow the latch arm to drop down.
vi)
Continue to unlatch the other side.
5.
Standing to the side of the ramp, lower the ramp down slowly.
Содержание Eventa L Tandem
