i
Wave GPS Module User Manual
REL1.9
iWave Systems Technologies Pvt. Ltd.
Page 25 of 29
(Confidential)
100—Set Serial Port :
This command message is used to set the protocol (SiRF binary or NMEA) and/or the
communication parameters (Baud, data bits, stop bits, and parity). Generally, this command is
used to switch the module back to SiRF binary protocol mode where a more extensive command
message set is available. When a valid message is received, the parameters are stored in battery-
backed SRAM and the Evaluation Receiver restarts using the saved parameters.
Table 13contains the input values for the following example:
Switch to SiRF binary protocol at 9600,8,N,1
$PSRF100,0,9600,8,1,0*0C
Table 13: Set Serial Port Data Format