i
Wave GPS Module User Manual
REL1.9
iWave Systems Technologies Pvt. Ltd.
Page 23 of 29
(Confidential)
8
Annexure
NMEA Input Message:
The below table lists out the NMEA Input Messages
Message
MID
1
Description
Set Serial Port
100
Set PORT A parameters and protocol
Navigation Initialization
101
Parameters required for start using X/Y/Z.
2
Set DGPS Port
102
Set PORT B parameters for DGPS input
Query/Rate Control
103
Query standard NMEA message and/or set output
rate
LLA Navigation Initialization
104
Parameters required for start using Lat/Lon/Alt
.3
Development Data On/Off
105
Development Data messages On/Off
Select Datum
106
Selection of datum to be used for coordinate
transformations
MSK Receiver Interface
MSK
Command message to a MSK radio-beacon
receiver.
Table 11: NMEA Input Messages
1.
Message Identification (MID)
2.
.Input coordinates must be
3.
WGS84.Input coordinates must be WGS84.
Transport Message
Start Sequence
Payload
checksum
End Sequence
$PSRF<MID>
1
Data
2
Checksum
3
End Sequence
4
Table 12:Transport Message parameters
1.
Message Identifier consisting of three numeric characters. Input messages begin at MID
100.
2.
Message specific data. Refer to a specific message section for <data>...<data> definition.