IVT Rego 5101, Руководство по установке

Страница: 5 / 40

Control panel
6 720 645 172 (2010/07) en
5
3 Control panel
Settings for the control of the heat pump are made with
the control unit's control panel, which also provides
information about current status.
Each heat pump is set using its control unit.
3.1 Panel overview
Fig. 1 Control panel
1 Status lamp
2 On/Off button
3 Menu display
4 Return button
5 Navigation buttons
6 Alarm button
3.2 Status lamp
The status lamp indications apply to the heat pump the
lamp is placed on.
3.3 On/Off button
Use the On/Off button to switch the heating installation
on and off.
When Off: The menu window shows Standby . The heat
system circulation pump E11.G1 keeps running.
Communication between the heat pumps is not
affected.
3.4 Menu display
Use the menu display in order to:
•
See information from the heat pump.
•
See available menus.
•
Change set values.
3.5 Return button
Use to:
•
Go back to the previous menu level.
•
Leave a setting display without changing the set
value.
3.6 Navigation buttons
Use the arrows to navigate between the menus. Press
to initiate a value change, then use the arrows to
change the value. Press to save or to return
without saving.
3.7 Alarm button
Use to show the alarm list (status lamp lights/
flashes red). To return to the previous position, press
or .
Alarms activated in a certain pump are shown in the heat
pump in question.
The lamp lights green. The control unit is
activated.
The lamp flashes green
slowly. The control unit is
switched off/stand-by
mode (Off).
The lamp flashes red . An alarm is active or has
not been acknowledged.
The lamp lights red. The alarm has been
acknowledged but the
alarm cause remains.
Tab. 8 Lamp functions
ok
3
4
2
1
5
6
6 720 641 739-06.1I
ok
ok