iVision IV-WP866PL, Руководство пользователя

Страница: 19 / 24

- 18 -
195 11000011 218 11011010 241 11110001
196 11000100 219 11011011 242 11110010
197 11000101 220 11011100 243 11110011
198 11000110 221 11011101 244 11110100
199 11000111 222 11011110 245 11110101
200 11001000 223 11011111 246 11110110
201 11001001 224 11100000 247 11110111
202 11001010 225 11100001 248 11111000
203 11001011 226 11100010 249 11111001
204 11001100 227 11100011 250 11111010
205 11001101 228 11100100 251 11111011
206 11001110 229 11100101 252 11111100
207 11001111 230 11100110 253 11111101
208 11010000 231 11100111 254 11111110
209 11010001 232 11101000 255 11111111
◆ If protocol, address and Baud rate are configured when power is on, then the IR Low-speed dome camera must be
switched off and restarted to make the configuration valid.
VII. Basic functions of the IR Low-speed Dome Camera
7.1 Power on and self-examining of the unit
Once power on, the unit enters self-checking procedure: it moves pan 360°, tilt 90°, then moves to its original position,
then the lens zoom from far to near, then from near to far. Through the self-check, the unit checks the mechanical
moving performance of the pan/tilt, the electrical performance of the controlling system, the controlling of the camera
module. After the IR Low-speed Dome Camera finishes self-check, it stays at the original position and is ready to
receive controlling instructions.
7.2 Configure and Invoke Preset Positions
The function of preset positions works in this way: the IR Low-speed Dome Camera saves the parameters of the
current pan/tilt angel and zooming ratio of the lens under a representing number, quickly invoke those parameters when
needed, the unit will turn to the corresponding position and be adjusted to corresponding zooming ratio. Users can use
such devices as controlling keyboard to save and invoke preset positions quickly and conveniently. The IR Low-speed
Dome Camera can support up to 64 preset positions.
7.2.1 Configure Preset Positions
After turning the IR Low-speed Dome Camera to desired position and adjusting to desired zooming ratio, through the
keyboard, enter the number that is to represent the preset position, press the “PRESET” key. Now you have configured
one preset position.
Example: Configure preset position No.1
a. Use the joystick to move the IR Low-speed Dome Camera to the desired position and adjust the lens of the camera
module well.
b. Enter “1”
c. Press the “PRESET” key